Both problems mentioned are correct. Setting the guide rollers can be tedious. You need to lay a square across the bed and up to the blade and a good light behind it so you can view the light between them. Remember the blade has a "set" to the teeth that makes them wider than the back. So with the square up against the teeth you should see light between it and the rest of the blade. You want that gap even. Then install a new QUALITY blade and it will cut square. Then try the old one and it it cuts crooked you know what to do with it. I got caught without a spare for my 7x11 saw a couple times and my experience with pre-packaged blades from the the hardware stores is dismal or worse. Go to one of the on-line tooling stores and have them make you up some bi-metal blades. Lennox, Morse and Starrett are all good brands.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.