Tool Talk Discussion Board |
Re: Cleaning cast Aluminum?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Little Ed on April 30, 2007 at 19:56:00 from (4.245.77.171):
In Reply to: Re: Cleaning cast Aluminum? posted by DNWELDMAN on April 28, 2007 at 10:43:57:
Glad to hear that I am not the only one that still has the occasional problem with cast AL. Sorry to hear that it will always be the same. One thing that I have found when doing oil soaked castings of AL, brass,and cast iron is that you are not likely to pre-heat it too much. My son was having trouble with a transfer case last weekend, and it didn't get any better till we heated it very hot all over, not just in the area to be welded. I have been known to heat a casting until the oil catches fire, and then keep heating it until it won't burn anymore. Good luck
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|