Tool Talk Discussion Board |
Re: Miller 6 pin TIG output remotes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by '52 Farmall H on February 15, 2007 at 19:45:19 from (208.101.172.84):
In Reply to: Re: Miller 6 pin TIG output remotes posted by 135 Fan on February 15, 2007 at 16:18:35:
I think the main reason the plug is different is size limitations. The Maxstar 150 is a very small welder: 9" H x 5.5" W x 13.25" L and 13.7 lbs. A 14 pin plug and even a 5 pin would be too big. You may be right about the signal power being different. In fact, I have looked at several different welder manuals and have seen all sorts of voltages and even polarity listed. I don't know much about electronics, but I have a theory that to a certain extent, the remotes can be used with different powers. Thanks.
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Electronic Ignition - by Staff. Oil, for example has come a long way in the last 50 years and I don't use anything but the latest API grade available. I've heard the arguments for non-detergent oils but would never trade it for today's formulations. Paint is another, the modern acrylic enamels are great for resistance to grease and fuel stains, retaining their shine and they last forever; unlike enamels and lacquers . Still another is the alternator. No doubt using the original generator keeps the tractor pure, but for thos
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|