Tool Talk Discussion Board |
Re: van norman boring bar and tooling
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bryan In Iowa on September 25, 2006 at 19:55:50 from (205.188.117.7):
In Reply to: van norman boring bar and tooling posted by Don Anderson on September 25, 2006 at 08:24:05:
I believe it is a 977 . It is an automotive block boring bar . I have block fixture , which is bloted to v8 block to hold decks horizontal . Several new bits and holders . I think it will bore up to 4.400 . I can check tommorrow . Also several hold down clamps to secure it to differant blocks . Can also get you pics if you'd like . I'd like to get $1200.00 out of it .
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|