Tool Talk Discussion Board |
Re: 3.5 horse pwr. murray pushmower
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Trailerman on August 03, 2004 at 15:07:06 from (12.43.224.185):
In Reply to: 3.5 horse pwr. murray pushmower posted by 1234 on August 03, 2004 at 13:09:35:
A couple of things come to mind... Check to see if your flywheel key is partially bent or sheered. If it is warped and not sheered completely, it might let it run, but be rough. Also you might check your level of spark from your coil/armature. Take the spark plug out, and either hold it or the spark plug wire (with a pair of insulated pliers or a screwdriver) hold it next to a ground (engine head bolts). Pull the cord. If the spark is blue, your spark is good, if the spark is not seen or is yellowish, it is weak. Check these and post your findings. If you have good fire (spark at the right time) then it has to be in the fuel system. Trailerman
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|