Remove the screen that covers the flywheel.That will expose the timing marks that are on the flywheel shroud. The flywheel is marked with the letters DC near one of the flywheel fins. the fin is further identified by an X mark cast on the end of the fin. Turn the engine over until edge of the marked fin on the flywheel is on line with the mark on the vertical line of the shroud. At this point the key way for mounting the flywheel is also on top. The magneto should now be fitted to the engine so the X marked tooth of the magneto gear is visible through the lower half of the inspection hole.
If the magneto is properly timed the impulse coupling will snap when the DC X marked fin lines up with the center line of the number 1 and 3 cylinder as marked on the flywheel shroud.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.