Tractor Pulling Discussion Board |
Re: Farmall H/M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John(AZ) on May 10, 2003 at 23:36:13 from (172.154.18.43):
In Reply to: Farmall H/M posted by '46 H on May 09, 2003 at 20:03:01:
I have a '48 H that I pull with, our club's rules say that the tractor must be stock with the exception of oversized pistons. we also can only use factory type weights that were available for the tractor, no suitcase type weights. I use 13.6x38 tires, one set of tire weights on the back. I pull in the 3500-4500lb class and my tractor weighs in at 4480 lbs. My tractor was overhauled using oversized High compression pistons and very light porting of the head. This tractor will probably never win it's class but it does a respectable job and it suprizes alot of those people that think H's never pull well! The power to weight ratio is just about perfect as I usually spin out just befor it would power out. It does make full pulls when the track conditions are right. We don't pull for prizes or anything, usually I get beat by the unstyled john Deere A's with mega buck engines that are nowhere nears stock, They shouldn't even be allowed to pull by our rules but it's all just for fun, so who cares?
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|