Posted by on a budget on March 31, 2013 at 12:05:43 from (166.182.3.55):
In Reply to: welded rods posted by JDguy1 on March 27, 2013 at 18:31:23:
A few months ago I brought up the subject of welded rods on this sight and was told what an idot I am and that it would never work. However, In 1995 i built myself a 521 inch 88 oliver with welded rods and after countless passes and four owners later the rods havent caused any problems. 25 years ago we didnt know what custom rods were. Custom rods are the best thing since sliced bread, They are strong and much less work is required to get them to clear the cam and block. You can choose a common bearing, and all you need is a credit card to get the ball rolling! Its kind of like buying a new car, if your pockets are deep you can drive a cadilac. If child support, helth ins, auto ins, and the cost of living is bitting you in the butt then you may have to drive a used toyota. Did I mention I have a chevy luv in my fleet??!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.