Posted by MLPANKEY on January 15, 2013 at 17:57:49 from (98.68.175.137):
In Reply to: Machine shop (pics) posted by mightymolinekid on January 14, 2013 at 12:37:29:
[quote="mightymolinekid"](quoted from post at 15:27:57 01/15/13) Southeast Wisconsin to be specific. Its a Moline diesel, they are designed for the pistons to come to zero deck. I have a question. I have valve contact with .012" lash now, how would putty on top of the piston tell me how deep the relief needs to be? Wouldn't it just mash it out when the valve hits? When I say contact, I mean it gets tight against the top of the piston when I roll it over by hand, I took the valve spring off and checked. I don't know much about the finer points of engine building, I had left that up to the shop, trusting their knowledge. Now I'm going to learn all I can, which I wish I'd done in the first place. Where is your shop located? How exactly do I figure out what I need for clearance? Thanks for the input and any help.[/quote. When it was first put together the squiahed puddy would have been the only indicator of piston to valve touching and or how much it wasnt touching
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.