Posted by charger66 on December 10, 2012 at 19:30:12 from (97.24.66.171):
We rebuilt the entire transmission including every single bearing, new bushings in the PTO, All shifter forks etc were gone over and properly adjusted, all tolerances were adjusted to spec, every part was scrubbed spotless, all oil holes chamfered, new shifter cup, ball, snap rings and gasket were all replaced on shift lever etc. Case was spotless and rare earth magnets placed in bottom of case. This tractor sees high use! The tractor still will pop out of third gear when under load.
The transmission drive gear and shaft assembly inlcuding nut part # AB4161R sub #AB3504R or gear only part # B2435R......and the sliding gear shaft drive part #B3613R sub #AB4193R were both substantially worn. We hoped with new bearings it would stay in gear but unfortunately it will not:(
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.