Only an opinion not etched in stone: Sheet metal #3&4: I didn't know you used hardener with CaseIH primer, is that on the can of their primer? If not you might end up with a mess. Best to use 2 coats of epoxy for #3, and use sandable urethane surfacer in #4. 3 coats of surfacer and sand, repeat until smooth. do not get it too thick, in other words you will sand most of it off. Remember that you need supplied air for the isocyanates in the hardener. If you don't want the iso's, there are other primers and surfacers that can be used that do the same thing, but they can sink into the sanding scratches. Or just use the CaseIH stuff without hardener. #5. You don't sand between coats unless you have a rough finish (poor technique) or runs in the paint. Do the cast the same except that you don't use surfacer. PPG numbers are Omni MP 170 epoxy primer, that uses a non-iso catalyst, and PPG MP 182 urethane surfacer over the epoxy on the sheet metal. For a non-iso surfacer use Omni MP 181. These should be safe to use under CaseIH 2150, I will not promise, but would not hesitate to use it myself if I ever get too poor to use acrylic urethane. Cost will be maybe $150 more than the IH products.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.