Antique Tractor Paint and Bodywork |
Re: bodywork on a JD H hood
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rustyj14 on December 02, 2006 at 13:15:32 from (71.245.179.159):
In Reply to: Re: bodywork on a JD H hood posted by 1951g on November 14, 2006 at 08:24:21:
When sanding plastic filler (Bondo) you should use open coat sand paper. There is a paper made that is 40 grit, which you should use to block sand the bondo. then use 80 grit paper to fine tune the sanding process. Always use the sand paper on a long block of wood, or something you can put the paper on. They sell a long sanding board, with paper clamps, that will take the "long skinnies" of either 40 or 80 paper, and which are great for finding low spots. Most if not all auto body supply shops have those boards available. Never use wet sandpaper on fresh cured Bondo! It will make it separate from whatever you put it on. After you have it sanded down to where you want it, then prime, and sand it with wet sand paper on a block. Use a guide coat, available at supply store, in a rattle can. Spray the guide coat on the job before you sand, This lets you see where the low or high spots are. A light coat is all that is needed, and block sand it when dry. Repainting is a tough, hard, time-spending task, if you want to do it right. There ain't any short-cuts. In as much as you have warped the metal by sand blasting it, you might be better off to buy another part. Or, take it to a professional auto body shop and have them fix up yer mistakes.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|