Posted by schim on May 27, 2013 at 05:08:06 from (99.47.236.63):
just fired up my 88 for the first time and have no oil pressure.oil is moving fine but there"s no pressure. block was completely bare when I got it so when we fired it up the first time it didn"t have the oil relief valve in it. went out back and robbed that from a different tractor. fired it up again no pressure. took pan off took pump off. pickup was really dirty... yea I mustve forgotten to clean it before I put it in. also the pickup seems to have oil in inside it like there is a hole in it or something. but when u shake it no oil comes out. veins are correct according to it manual. put the pump in a bucket of oil and it pumps fine. put it all back together and fired it up still no pressure. my question is am I forgetting something else in the block somewhere? is there another hole that needs to be plugged inside? are my main bearings installed wrong somehow? crank and mains were in the block when I got it... and no were not going just by the gauge.we r taking the gauge wire off at the block I would assume u shouldn"t b able to hold your finger over that hole while its running? the oil comes out of the hole fine there"s just no pressure behind it....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.