Posted by The tractor vet on February 25, 2013 at 11:26:47 from (76.212.232.79):
were not working to hard on this but sofar things are moving along . We have the new flywheel just one tiny little snag there is the starter ring gear , we have two choices here (one that came with the donor engine is a 126 tooth ) the one on the NEW flywheel is a 156 teeth i think , sorta forgot at the moment .So we are at this time looking into either a different starter drive or new starter . The next hurtle is fan hub as the one on the engine is 12 inches from center of crank , the one on the herc is 16 inches from center, just solved that problem with a call to the Come A Part store and the fan hub we need is setting on his desk. This is way to easy to the point it has to be illegal. Like i said we are not working on this real hard and we are only doing about three or four hours a day and lots of talking and not much work. The rear lifting bracket will have to come off the engine as it hits the fuel tank and we will have to trim the ft drive axle support a whisker for pan clearance . Forgot the camera the other day but i will get some shots .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.