Posted by Jim Meade on December 15, 2012 at 12:34:47 from (208.126.218.108):
1855 #A has a crack in the flare end of the metal high pressure hydraulic line that wraps around the cast housing. 1855 #B has a good line but I want to tap it for use on a loader. I'm thinking I will take the good line off #B and replace it with a hydraulic hose with a T in it to tap into for the loader. I could use the good line off #B and put it on #A, or I could put a hydraulic line on #A as well. A new steel line is about $100. A hydraulic line would be much less than that. 1. Any suggestions or comments on the above ideas? 2. How do I get at the right hand fitting of the hydraulic line to remove it? Remove the floor board? Both tractors have cabs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.