Posted by skyler on June 17, 2013 at 00:38:46 from (72.160.138.99):
Hi, I have a 8n coil not making contact front mt. (1949) new 12vt coil. It seems the metal tab on the coil (outer part, not pigtail) is too far away from the contact on the distributor cap.( yellowish brown one) any comments? also the four sparkie inputs on the cap are numbered. 1234. So I assume the plug wires from the sparkies just match to those inputs on the cap. 1 being closest to the front on the tractor and so on. How does this have anything to do with the firing order 1243. The wires still go to the numbers on the cap, correct? I hope this makes sense it is very late here and I"ve been working on this for 3 days. It ran rough under load and would stall. New cap,coil, condenser, wires, plugs, block resistor, ceramic resistor, and tons of reading. Points at 15. tried 18, got worse. some backfiring, Now no rpms, rough running, cant leave the barn. Fuel is next after I go back to 15 on the points. It comes out of the bowl drain, but kinda slow. all filters cleaned. Thanks for listening, Cal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.