Posted by xj4343 on June 12, 2013 at 15:42:43 from (22.214.171.124):
Just started the 9n today after a total restoration. Primed the oil pump. turned over with just battery until I got some oil pressure. turned on the gas and ignition fired right up. felt pretty good till i got to the end of the drive way(about 30 yards) and realized I had 50 plus on the oil pressure gage and oil was coming out of the filter housing and junction block. I have a new plunger,pressure spring, oil pump rebuilt and a new gauge. Running 10w-30 rotella, primed pump with stp. what do you think? She sure sounded good for a couple minutes
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.