Posted by Tom in MO on April 29, 2013 at 09:57:03 from (64.136.27.163):
Dell: I read your archived post about the "20/20" Brush/Roller Paint Job, which I plan to do on my Fergy TO-20.
I don"t have the facilities, equipment, ability or desire to spray with automotive paint, as I don"t need that kind of end result for a Workin" Tractor.
Question(s): 1. For the rolled paint on the sheet metal, do you figure on just one coat? Same for brush on castings?
2. Do you prime over old, but sound paint on sheet metal/castings, or just areas that are down to bare metal after sanding/cleaning?
Can you use brushed/rolled primer, too? Does it need to be sanded, before applying the topcoat?
3. I know your instructions call for acrylic automotive enamel, but I"m planning to use VanSickle alkyd enamel, with hardener, mainly because they have the Ferguson color in stock at my local farm supply store.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.