Posted by Kurt-NEPA on January 07, 2013 at 14:18:32 from (184.108.40.206):
In Reply to: 51 8n posted by Lisa K on January 07, 2013 at 07:04:10:
Line up the marks on the crank and cam gear is correct. Double check it.
Did the machine shop grind the valves and/or seats. If yes, the valve will need to be adjusted. Do you have adjustable lifters or the older solid ones? In any case I would follow the manual and check the clearance.
Most of us oil the rope seals and press them into the groove with a large socket. Then trim the ends with a sharp knife or razor blade about 1/16" proud. I would search the archives on this, many posts on it both here on YT and on the other N Tractor board
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.