for s&g, clean points, unhook vreg bat contact and field, pull plugs.. dump a couple tablespoons of atf down each hole and let set.. clean plugs.. block clutch, place in neutral, after blocking tires.. roll engine over a bit manually.... .. use a jumper cable and your truck battery and run engine over with plugs out to expell oil.. put plugs in..
try to start her.. use start fluid f needed.
make sure to check oil and water first.
she just might start up...
if so.. watch oil pressure.. if it don't come up in a few seconds.. shut down.. pull large oil plunger relief plug on front of engine.. don't loose spring.. dump in a few oz of thick oil down the hole.. slamp in and restart.. oil should pickup...
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.