Posted by rustyfarmall on September 21, 2012 at 09:29:52 from (22.214.171.124):
In Reply to: Carb mystery posted by W_B on September 21, 2012 at 08:38:16:
Just a wild guess here, but did those carburetors have any kind of replaceable bushing for the throttle shaft when they were new? If not, maybe the area where the throttle shaft fits became worn enough that even a NEW throttle shaft wouldn't fit good and snug anymore, so the original hole was drilled out and a brass bushing installed?
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.