Posted by JPinWI on March 10, 2008 at 10:58:58 from (22.214.171.124):
Not sure anybody saw this on the end of my previous post....
It looks like I will have to take the front end off to replace the fan belt on this 8n. There just isn"t any clearance between the crank pulley and the front motor support housing. By the way this 8n has a freeman loader on it (thus the front Hyd. Pump) so I am trying to figure out the best (safest) way to proceed. I have a jack supporting the front of the engine and s 2x6 on jack stands to catch and slide the front axle assembly on. Anything else I should be prepared for? Also, Where is the best place to take apart the steering linkage? I banged abit on the linkage at the end of the spindle arm but it didn"t seem to want to go anywhere. Tips appeciated!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.