Ford 9N, 2N & 8N Discussion Board |
dist?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by hndymann22 on June 03, 2007 at 18:07:25 from (64.250.209.108):
Ok I got a 12volt coil. and it came with a inline resistor. havent got the alt. or wireing all on the tractor, but was wanting to see if it would start. I put new points and cond. cap, coil and resistor and plugs on it. run a hot wire to resitor, than to coil. and jumped it at starter. would crank great but no fire. So I took dist. off check points, sit on 15 gap. no wires grounded. would not leave wire hooked up for more than 5 or 10 sec. at a time didnt want to burn up points. Do you guys think the dist. is shorted inside. I bought this off of ebay cause the 2n didnt have one when I bought it. Think I should change the breaker plate in it? Any thoughts would be great. I just have put in so much time on this, I would just like to hear an idle out of it. Would give me an extra jumpstart to keep going...lol..Anyway thinks guys for all the help u have gave me so far on this sweet thing I bought.
Replies:
Home
| Forums
Today's Featured Article -
Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|