Ford 9N, 2N & 8N Discussion Board |
Re: Ford 8N Hydraulic Pump Removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dell (WA) on November 04, 2006 at 14:02:12 from (172.191.238.236):
In Reply to: Re: Ford 8N Hydraulic Pump Removal posted by Bob on November 04, 2006 at 13:33:01:
Jim.......what Bob sez........the "twist" in the PTO shaft is usually imperceptable and usually don't hurt 'nuttin' until it comes time to remove the $$$ hydraulic pump. Like now. New modern 1-3/8" replacement PTO shaft $150 (cheap) Usually, you can reach it with a "saws-all" thru the removed 6"-dipstick cover plate. Don't have a saws-all? rent one. Simple, eh? It usually gitts twisted by brushhoggin' without an over-running coupler (ORC) $65 (cheap) ........Dell
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|