Posted by newfarmer9 on April 25, 2014 at 20:31:52 from (184.108.40.206):
How do you remove the front (vertical) pin on the power steering cylinders on a G1355? I have the rear (horizontal) pin removed, both hydraulic lines on each cylinder off, and the snap rings on the front (vertical) pins removed. The front pins need to go up to come out, however there is only a fraction of an inch of clearance between the top of the pins and the cast radiator mount.
I see there are large holes in the rad mount to the rear of the steering cylinders, however even with the tie rods off and the tires jacked off the ground I can't pivot the steering mechanism far enough back to push the pins up and out of the hole. Any help?
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.