Posted by pplowboy on September 11, 2012 at 16:13:38 from (70.194.11.140):
In Reply to: Re: big cube diesels posted by billy39 on September 10, 2012 at 17:19:23:
Hey billie. Maybe this help ya.parts goin to varydo to area your in. Maybe jugs big hole gona cost ya 75 -150. When u get the jugs look at the center stud hole , prone for cracks, problem before use that jug. Wher they are an shipping.but as soon u start looking. More names an no. For parts will come as u look for the parts.. you gvi heads are problie tighter chambers heads..u could find newer heads. Flow better air but if you run close to stock. Your heads work. But you could get $500 apease in heads. Maybe more or less on the cost you machinist. Used pistons might run 60$ new one arnt cheap.150 -...maybe you want custom.. may get 350 apease in them... are you goin use 6" crank.. then piston,an rod combination. Is a queistion. U want new m.m. rods.but if you use gas crank. Rod journal different size. But easily over this issue. How many rpms u want turn? Thats a factor..my area ther no minnies parts are hard to find..jus some ideas on prices giv ya some ideas.hope this helps.im sure other guys on here can lead ya to parts to.may find what you need cheap to get ya pullin
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.