Hello if you have a head gasket that left go it could have filled a cylinder or two and if one of them was coming up on compression it would hydro lock the motor. Happened to me some years back, just put three new heads on a G-1000 Vista and had it running good came back to it in the morning and it wouldn't turn seen a little water trickle down from the exhaust manifold on number 6 cyl. so I pulled the injectors on 5 & 6 and hit the starter and it shot water clear across the shop found the block was cracked in the number 6 hole and it opened up from running it the night before so I had to pull the back head and block and replace the block.If it had anti-freeze in the oil I'd pull the pan and maybe the bearing caps to try and get it all off the bearings so the don't get wipedout form lack of oil. joe
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.