That pumps looks to be the common loader 8-10GPM pump like my fords have. You will need to replace the crank shaft pulley with one that is drilled and tapped to mount a spline hub on and then get the spline hub and shaft. Most good tractor dealers should have that type of hub and an AGCO dealer would be your best bet. This past fall I did a shaft repair thing on a 3000 ford where the guy had broken the loader mounts and in turn broke the shaft drive and found the parts at the local Ford/New Holland place which was also the AGCO dealer
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.