Posted by Zachary Hoyt on January 31, 2013 at 15:38:59 from (50.122.169.86):
I bought this Davis MF 101 102 loader in 2008 and put it on this tractor using the hoses that were on the loader and the internal pump output on the side of the tractor under the seat. I mounted the valve on a plate so that I could run the return from the valve back into the transmission sump. That worked okay but it has tended to leak a bit at the top of the plate and the valves both leak too as can be seen in the photo. I have gotten a lot of good use out of the loader and I think it is time to fix it up a bit better. I have an old front mounted pump that I bought a couple of years ago and would like to use if I can find all of the parts to connect it to the crankshaft. I think it may fit an SAE A mount but I will need to measure. I am wondering if anyone knows what the GPM of this pump may be so I can get a suitable spool valve, or where I could find the shaft and whatever other bits may be needed to hook it up. I am also wondering if anyone knows what the capacity of the reservoir in the loader subframe may be. Any advice will be very much appreciated. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.