Thanks for the picture Sam. I do not have that tool but made the one from the I&T service manual I have. I read your post several times David and things are making more sense. The height does not have to be exact as long as all three fingers are the same if I am thinking correctly. You can make adjustments at the release bearing to compensate for any difference. The old pto disc had a sprung(convex) side and the new one does not so that is what had me confused about which way to install it. I hope to work on it some this evening so I am going to double check The pto disc installation. Thanks for the help.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.