Posted by Vern H on September 04, 2013 at 17:14:03 from (75.211.123.14):
In Reply to: Stuck B piston posted by Todd in NC on September 03, 2013 at 15:48:39:
Todd, Looks like you are getting a lot of good advice on here. Here is a little more. Another method is to make up a steel plate with holes to match four or five of the studs, place a block of wood of proper size and shape on top of the piston, place your plate on the studs and block, and use the nuts to put the push on it. The wood block should be end grain to the piston and plate. When you get a strain on it, smack it with your best (biggest) beater. Something has to happen. I would think a minimum of 1/2" plate. Good luck. VH
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.