Posted by Todd in NC on September 03, 2013 at 15:48:39 from (220.127.116.11):
I'm working on a 1950 B John Deere. This is the gas engine, not an all fuel. It's got aluminum pistons. One piston is stuck and won't move with conventional methods. I've tried soaking with PB Blaster, ATF & gas mixture, and MMO. Then, used a big hammer and block of stove wood. It don't move. Now, I can heat it, or put it in a big press. In other words, I CAN GET IT OUT. I'm sure it will need to be bored,but, I'm not wanting to destroy the piston, or anything else if I can help it. Does anybody have any suggestion or experience with this. Thanks in advance. Todd.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.