Posted by bigboreG on August 20, 2013 at 17:40:33 from (69.66.252.170):
Recently purchased a 1958 model 620. Tractor is in great shape and is mechanicly sound. Compression readings are 125# both sides. Anyway, when the tractor is first started and you take off in road gear, it feels like there is a pull to the left in the steering. If i let go of the wheel it will veer left. As the tractor warms up, lets say after ten min or so, the pull goes away and when you let of the wheel it will drive straight for a long ways.one finger steering at idle sitting still. Roll a matic narrow front. Any ideas? Also are front wheels stamped 1268 the correct front rims for this tractor? In the narrow postion the center rib of a 6.00 -16 tire sticks out past the frame, when wheels dished the other way they really get wide. When comparing the roll a matic to other tractors in my area,the wheels sit closer together, and the knees look thicker and more heavy duty. Could it possibly have a heavy duty front end on it? Or was something like this even available at the time? Thanks in advance!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.