Posted by jd2cylman on October 03, 2012 at 18:25:38 from (67.167.218.125):
In Reply to: 820 identity question posted by cannonball on September 29, 2012 at 17:47:39:
Russ,
If the rims on this 820 have two ribs on them, then they must be the 34" hubs (or they're not the correct rims). For the 26" hubs, the rims only have one rib, and the rim and tire assembly get turned around to have the dish "in" or "out". In fact, I think the 34" rims were the same way. I'd have to look when I get home tomorrow. I had an 820 with 26" hubs and I sold the R1600R hubs and put on the R2522R hubs so I could use 20" rims for my new 23.1x26 tires and dish them in. Saved a lot of shed space. For the 830, Dad said no 26" tires.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.