How often do you use draft control. If never, take those bushings to a machine shop. Have them make you some with a straight center hole,(no taper), install them and then throw those originals in the junk. Not one of Deere's better ideas. I replaced a lot of busings, seals and shafts in just four years of working at at Deere dealer. I never was able to go with my idea as of course everyone wanted it like it was originally. IH tractors are no better, as they wear out those expensive splined shafts and connections and no one ever uses draft control anyway.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.