Posted by JDBert on May 21, 2009 at 06:45:57 from (71.32.130.203):
In Reply to: 4020 cab? soundguard posted by wendelin on May 19, 2009 at 15:33:07:
The hinson cabs aren't all that bad- yeah not a soundgard but still better then nothing- you GOTTA have one with A/C!!! The 4020/4320 cabs are the same BUT the 45/4620 5020/6030 cabs have a roll bar made of solid iron where the 40/4320's are hollow. The best place to start on these is to put rubber between the rollbar and axle, on the hollow ones drill a hole in the top and fill them with sand. Get a good interior kit in them and put a extra floor mat in them. I replaced a couple of steel lines that come up into the steering column with hydraulic hose's and that helped as well. I did this on my 4620. On the 4320 we have we did the soundgard conversion with out removeing the steering console BUT I've seen it done using the shifter and steering console of the soundgard- I would assume by the looks of it thats a job!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.