John Deere Tractors Discussion Board|
John Deere G Wiring Diagram
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by D6ugan on December 01, 2005 at 13:26:14 from (22.214.171.124):
I just got a new "original" generator and voltage regulator for my G, and could use some help in wiring the tractor. The wires from the regulator to the field and armature are already installed.
Tractor serial 25251
3-terminal saddle-type regulator (no “L” terminal)
My parts book has a real poor diagram that shows a wire coming from the light switch to the "Field" terminal on the generator, and a hot wire from the amp meter to the "BAT" terminal of the regulator. It also shows a fused wire from the amp meter output terminal to the light switch, and a wire going from the switch to the lights.
The wire going from the light switch to the generator field terminal does not make sense to me, but if it’s accurate, does the wire connect to the input side or the output side of the light switch? (My light switch is a single-pole toggle switch, which I doubt is original and may add to my confusion.)
Any pointers or a wiring diagram, would be greatly appreciated.
|Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]|
| Copyright © 1997-2015 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters