Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
John Deere Tractors Discussion Board

Re: Re: Wiring diagram for STX-38


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by spleen on June 26, 2005 at 17:40:24 from (24.151.138.63):

In Reply to: Re: Re: Wiring diagram for STX-38 posted by Kyle Ann Christian on June 24, 2005 at 08:30:04:

not sure if this will help - but I had a lot of trouble with my stx38 (black deck). Sometimes had trouble starting, then once up and running and mowing, the mower would kick off for no reason.

After a lot of checking of this and that, I found I could start the tractor by turning the key verrrrry slowly right to magic point where it would connect the starter.

It was very intermittent problem so it was very frustrating, it progressively got worse.

At first I didn"t think the two problems were related - but they were. I found I could get the mower started by turning the key back a bit while running.

Call me lazy, but I actually mowed my entire two acre lawn twice using this "fix". Very painful on the fingers - I don"t recommend it.

When I finally got around to it, swapping out the ignition switch fixed both problems.

Very easy fix. I pulled off the back wheel for breathing room, but you really don"t need to. Remove the two bolts under the fender that hold the whole plastic switch assembly together. (just the two rear bolts - you don"t need to remove the two front ones - it"s not obvious, but the whole top assembly is a two part ordeal)

The whole top piece with the switches pops out. - Just disconnect the plug from the switch. Then on the top, use a screwdriver to pop off black plastic cap that surrounds the key hole. Undo the big nut that holds the switch in - reverse the whole operation with the new switch and you"re done.

... unless of course like me you need to file down your rusty old key so it will fit the new switch....

very easy fix.


Follow Ups:




Post a Followup

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy