Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
John Deere Tractors Discussion Board

Re: Clooney or John T


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Clooney on June 23, 2003 at 04:05:11 from (198.208.223.35):

In Reply to: Clooney or John T posted by Jim on June 23, 2003 at 03:30:18:

Jim, you have conflicting adjustments you are making on that carb. By running with the choke 1/2 on you then need to lean the load needle out to 3/4 turn.
~Try the load needle out about 1-1/2 to 2 turns & no choke. If that helps you are good, if it still won't run you have still have a carb problem or real weak ignition.
~Start with a spark test..Take an old [known good] spark plug & open the plug gap to 3/16”, then install in one plug wire at a time & lay on the block, then crank the engine & look for a bluish spark to jump that gap MULTIPLE TIMES in a row. If you don’t get a bluish spark to jump that gap multiple times in a row you have a weak spark [post back with mag type & we’ll talk you through a mag troubleshooting sequence].
~If you are getting a good spark, then off the carb comes again as you missed a passage or transfer hole in the carb. If your problem is still in the carb E-Mail me & I will send you a carb breakdown showing you ALL the holes & passages that need cleaning for proper carb function. Most books & on line pictures don’t show all the carb transfer holes in those DLTX carbs..
JDClooney@aol.com



Follow Ups:




Post A Followup

:
:

: Re: Re: Clooney or John T

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy