Posted by JD Seller on August 17, 2013 at 05:53:58 from (208.126.196.144):
In Reply to: ford 515 mower posted by jleus on August 17, 2013 at 05:11:52:
You need all the guards to be the same height. I do not think the double guards cut as well as a good single guard with a good ledger plate. With good ledger plates and a under serrated section they will cut as good at they ever could.
The biggest draw back to the double type guard is that they do not have a ledger/wear plate. So the bottom of the slot wears and you keep adjusting the sickle down to it. Then you break a guard and the replacement is not worn. So now you have a taller guard in the mix. You have to allow the sickle to ride the high guard. So then the rest are too loose.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.