Posted by Banditfarmer on April 21, 2013 at 16:31:36 from (174.101.148.247):
Hi Frank I have a guestion on the GT 1006 No-Till Drill, Ware do you get your parts from? While going over the drill today I found several loose bearings. I got them all tightened up and the seed tube adjusted like you said and did good till I got to the last one and found a bad bearing and hub assc. that are going to have to be replaced. The nut side bearing had been loose for a while and has eat the stub shaft up to ware it wont hold a bearing anymore. I have the number for Moore in Ireland 011-4428276644 and one for a dealer in Ontario Canada 416-247-7875 and was wondering if you know of any others that might be in the USA to get parts from? The part # in my book is #731710 for the hub and bearing and part# 730450 right and #730460 left bearings. The bearing I could read is a Timken DUO-FACE-PLUS( #L44600L on the seal) #L44642 Timken Made in England on bearing. I hope you might be able to give me some ideas before I start calling Canada and Ireland tomorrow or if you or anyone else know another source in the USA to get parts from. Thanks for any help you can give me. At least its the easiest one to work on. Bandit
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.