Posted by Edd in KY on October 27, 2012 at 10:30:16 from (98.23.61.185):
I bought an old roll baler with a hydralic tie.
The arm moves across the bale (either way as the operator directs) then cuts and flips back to the start position.
I don't do many bales so my skill level is low but i really don't know what the best method is to get a decent tie.
Don't tell me to read the manual...i've done that.
Sometimes the end of the string gets caught by the feed-in material and is tying before I realize it. How do I prevent this from happening?
Do you start your tie by moving the arm to the middle then move back to the right side then back across the middle and on the the left edge before cutting the string?
How many revolutions make a good solid tie?
I am hoping for some simple practical advice from someone with experience, and good skills.
I don't think the brand of baler is real important to this process...or is it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.