Implement Alley Discussion Board |
Re: square baler required HP
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on December 09, 2006 at 19:43:19 from (4.244.186.27):
In Reply to: Re: square baler required HP posted by tractormiallis on December 09, 2006 at 19:25:42:
Best way if you want a new baler is look at the manual for the one your looking at. The manual will tell you max/min HP needed to use the baler. An example of that is my NH 850 round baler, the manual says min. HP of 55 and max of 75HP. Your WD has around 34HP so it will handle a good number of balers but there are one out there that would probably be way to much also. I know the 14T and 24T and a few other JD balers would work well with your tractor
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|