Implement Alley Discussion Board |
Re: PTO U-joint cross bearing removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J Schwiebert on November 13, 2006 at 18:36:11 from (209.143.51.226):
In Reply to: PTO U-joint cross bearing removal posted by Paul Schultz on November 13, 2006 at 18:08:24:
Its called a big hammer and a good size vice. Now next question is your new shaft a direct replacement for the old shaft/ If not there are what I used to call "jump joints" that will let you assemble shafts with different yokes. Make sure you take the snap ring off first and keep one for a spare in case one goes flying. The needle bearings for the cross are pressed in. Another reason for the vice. Questions? J.
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|