Implement Alley Discussion Board |
Re: PTO U-joint cross bearing removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul Schultz on November 13, 2006 at 18:50:09 from (75.45.196.234):
In Reply to: Re: PTO U-joint cross bearing removal posted by J Schwiebert on November 13, 2006 at 18:36:11:
I placed it into a vice and used a large sized socket to allow me to drive the cross bearing so that it would be offset in the yoke. I was then hoping the opposite side of the cross bearing would protrude from the yoke enough for me to get the cap off. I'm still trying to figure out how to get the bearing out at this point though. I assume I will need to get both caps off prior to being able to wiggle the cross bearing assembly from the yoke. Since it isn't budging I assume I have some rust locking it in place.... I have the snap rings off already. Is my described method acceptable? I've never dealt with this type of repair before. Paul.
Replies:
Home
| Forums
Today's Featured Article -
Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|