Posted by steve in wi on October 27, 2012 at 13:44:05 from (70.194.130.221):
In Reply to: 715 grinding corn posted by steve in wi on October 24, 2012 at 17:24:24:
OK,I set the concave to spec,checked beater,set both sieves to om,checked elevators good,and slowed fan speed.the cyl will only go down to 450 425 and that's it the belt is even with the pulley so that's as far as it will go.cobs are coming whole and clean out the back,just the very small kernals are on the cob.opened the sieves to get trash into tank.how much grain should be going threw the tailing elv?,I just thought of the feeder house was causing something,have to check when I get back out.thanks steve
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.