Posted by steve in wi on October 24, 2012 at 17:24:24 from (184.108.40.206):
I have a 715 and when I did beans last year worked great,very good threshing of the pods well this year I went to switch the concave over,lower it,I did what the book said 7/8 to one inch.one inch is where it stopped moving anyways.cyl speed was 460, opened up the front concave all the way,tried it in a few spots.fan speed up 840 and i get broken kerenals out the back,maybe I,am not putting the measuring tool in the right spot,but I still need to move the rear move,any ideas,? I,am going to look over the book and parts sheet when I get off of here,thanks steve
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.