Garden Tractors Discussion Board |
Re: Tire Assembley Stuck on 1970s Murry 11
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pollack Pete on May 26, 2006 at 05:28:44 from (67.72.98.45):
In Reply to: Tire Assembley Stuck on 1970s Murry 11 posted by (None) on May 25, 2006 at 19:39:01:
Not to answer a question with a question,but how did the bolts fall out past the wheel?If there was room for them to come out,there has to be room for them to go back in.If all else fails...keep soaking with penetrating oil...maybe put a little heat on the wheel hub?Good luck.It should come off without too much trouble. When you do re-nstall it,use some never-sieze on the axle to avoid this again.
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|