Garden Tractors Discussion Board |
Re: Cub Cadet 149
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by R Bedell on March 09, 2006 at 10:31:31 from (69.29.224.142):
In Reply to: Cub Cadet 149 posted by treeman on March 09, 2006 at 09:40:31:
Go to the front of the tractor. Get down and look at the axle. Look at the Cross Member, there should be a Collar weld to the cross member. The axle pivot pin is held in place with a small diameter retainer pin (3/16" x 1-1/4") that goes into the collar and pivot pin. That has to be driven out before the pivot pin can slide out. The retainer pin can be rusted in there and can be a PITA to get out. Remedies include: soaking with a penetrating oil, heat, and/or drilling out.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|