Posted by richard bartlett on February 03, 2011 at 12:30:51 from (81.129.125.244):
This is a follow up to an earlier question by me on this forum concerning a bad fitting FMD bonnet. I have assembled the bonnet and had to file all the holes to accomadate the release handles both supplied by the same pattern part supplier, Agriline. I've also had to adjust the holes in the new front cowl to accomadate the new badge, both from the same supplier. These are just small examples showing that the supplier has never tried to put together their own parts and found they dont fit. I and I bet many of you have had to 'adjust' many new parts to get them to fit and I think this is wrong so I intend to write a letter of serious complaint. Britpart supply pattern Land Rover parts and built one from scratch just using their own products to prove the quality of their parts. I bet there isn't any pattern part supplier of tractor parts that could do that. Has anyone else sent any letter of complaint and did you get any satisfaction? Glad to get it off my chest, cheers, Richard.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.